万博体育官方网站下载-信誉保证

  • The use of the machine

  • Update:2015-07-23 09:22:44

Universal machine to open up the operation is simple, actually otherwise, there are many road, want to share with you today is universal machine use method, to read:

1, first determine roller and lower roller in the state of parallel. Between the upper and lower roller is greater than the thickness, then one end into the sheet metal, make the plank end face and the roll parallel bus, two screw down a certain amount at this time by manual operation, start the motor switch (must be from work) at this time sheet metal bending deformation, repeated adjust down the repeated scrolling, until formation required curvature radius of the cylinder.

2, and the size of the roll taper head (not with taper attachment cannot), should do the following work:

(1) general points 2 to 3 part ZhuiTiXing crossed blanking, should first used his small mouth face grinder to grind, in order to slow down stuck on the plate.

Rolled plate (2), the first roll to roll center point radian, then slow down plate in the rear near the small mouth side friction speed down, according to the size of the head diameter ratio to adjust roll on two degrees, to remember the two head square set down the basic foundation of the roller, can control law.

(3) due to the roll taper is overloaded operation for plate bending rolls, so must always pay attention to every detail of machine tool, to ensure that the roller location ring and wall body between both ends should have good lubrication, especially the legs behind whether abnormity, if there is any abnormality should be resolved in a timely manner.

3, handling method of feeding mode is: roll on both ends while increasing gear roller fixed on the baffle, the roll the tail tight barrier, then end screw up and down button to move the mold to the bolt looseness, pull out the bolt, screw, left sleeve positioning ring, fall activities support, such cylinder can be removed. Continue to work should be according to the original process recovery activities support the same.

Only the correct master the use of the universal machine, to better use.

Source : (Edit:sxadmin)