万博体育官方网站下载-信誉保证

  • Universal machine operation should be prepared before the technical requirements

  • Update:2015-07-23 09:17:28

1, rolled on the universal bending roll bending, plate bending on both ends can be held on this machine. Put steel flat between upper and lower roller plate bending rolls, steel plate face should be parallel to the axis roller, end face should be higher than that of vertical shaft roller up and down the middle line distance.

2, the lateral axis roll promoted tilted upward move, let a steel plate end wall bending, a wall to move forward a distance, bending plate end, and in the same way to make the other side of the plate bending. Bending length should be apparent size to determine the layout of the machine, bending of circular arc with regard to quality requirements.

3, bending steel plate bending section shall, from time to time with templates raid curvature radius, the place where the local convex or concave, available steel bar as the liner to correction. When using bending roll bending, should according to the material of plastic, thick plate bending process code and the size of the curvature fractional completion.

4, deal with a straight segment bending allowance after bending, allowance shall be removed on both ends of the steel plate, the interface (groove) side and two side is not less than 20 mm category must clean grease, rust and scale.

Above is the universal machine the preparation before installation requirements, hoping to help.

Source : (Edit:sxadmin)